Theory · C Licence - Truck · Module 18 of 18
You learn to observe, anticipate and maintain space to drive your lorry safely and use its energy without unnecessary acceleration or braking. You master gear selection, the economical engine speed range, the influence of tyres, load and aerodynamics, and questions on environmental badges, ZBE (low-emission zones) and noise.


Observe, anticipate and leave space to drive safely and save fuel.
Exam trap: Wrong: save fuel even if you lose control. Right: save fuel only when it is safe.

Plan a route that suits your lorry, load and deliveries.
Exam trap: Wrong: always choose the shortest route. Right: check the whole journey.

Look well ahead, and check nearby areas, both sides and your mirrors.
Exam trap: Wrong: treat 20 seconds as a required following gap. Right: it is only an observation guide.

Check your mirrors and vision aids while watching ahead.
Exam trap: Wrong: stop watching ahead when checking mirrors. Right: keep watching ahead too.

Expect mistakes from others and signal your manoeuvres early.
Exam trap: Wrong: assume your indicator guarantees others see you. Right: check before manoeuvring.

Leave enough space to stop safely and respond smoothly to traffic.
Exam trap: Wrong: brake sharply to correct a close follower. Right: increase your space ahead.

Start and move off by following the manual, without needless revving.
Exam trap: Wrong: make every engine idle for a fixed warm-up time. Right: follow its manual.

Use the rev counter and engine response to choose an economical engine speed.
| What you check | What it tells you |
|---|---|
| Speedometer | Lorry road speed |
| Rev counter | Engine speed |
Exam trap: Wrong: treat the green zone as a fixed road speed. Right: it guides engine speed.

Choose a high gear only when the engine responds well.
Exam trap: Wrong: always use the highest gear. Right: choose a gear that suits the effort and engine response.

Use the clutch and automatic systems according to the manual.
| System | What to remember |
|---|---|
| Synchronised manual gearbox | Avoid unnecessary double-clutching |
| Unsynchronised gearbox | Follow its specific procedure |
| Automatic or automated gearbox | Intervene when conditions require it |
| Eco mode | May change response, gears or auxiliary equipment |
Exam trap: Wrong: assume an automatic choice is always right. Right: watch the road and act when needed.

Keep a steady speed and slow down when conditions require it.
Exam trap: Wrong: treat the limiter setting as a target speed. Right: adapt your speed to conditions.

Ease off early and keep a suitable gear engaged when slowing down.
Exam trap: Wrong: assume lifting off always stops fuel use. Right: it depends on the system and conditions.

Anticipate slopes and choose gears that keep your lorry under control.
| Situation | What you must do |
|---|---|
| Climbing | Change down if pulling power is lacking |
| Descending | Control speed with a gear engaged, retarding systems and brakes |
Exam trap: Wrong: use the same gear on every hill. Right: adapt your gear choice.

Avoid unnecessary idling and obey rules that require you to switch off.
| Term | What to remember |
|---|---|
| Idling | Engine running without pedal acceleration |
| Neutral | Transmission position; the engine can still use fuel |
| Fuel-saving advice | Switch off for expected stops over two minutes, unless auxiliary equipment needs continuous operation; follow the manual |
| Duty in a tunnel or enclosed place | Always switch off when stopped; after more than two minutes, keep the position lights on |
Exam trap: Wrong: confuse idling with neutral. Right: distinguish the engine from the transmission.

Check cold tyre pressures against the values for your lorry, tyres and load.
Exam trap: Wrong: lower tyre pressure automatically when carrying more load. Right: use the values that apply to your lorry and load.

Use the specified tyre pressure and understand what the tyre label tells you.
| Pressure | Possible effects |
|---|---|
| Too low | More rolling resistance and fuel use |
| Too high | Poorer road contact and wear in the tread centre |
Exam trap: Wrong: overinflate to save fuel. Right: use the prescribed pressure.

Plan and secure your load to save energy and keep the lorry stable.
Exam trap: Wrong: assume unloading always improves weight distribution. Right: check the remaining load distribution.

Consider your lorry’s shape and the wind when assessing fuel use.
| Wind | Effect to know |
|---|---|
| Headwind | May increase air resistance and fuel use |
| Moderate tailwind | May reduce air resistance |
Exam trap: Wrong: assume a lower Cx guarantees stability in a crosswind. Right: assess the wind.

Adjust deflectors and secure coverings to reduce air resistance.
Exam trap: Wrong: assume any spoiler saves fuel on every lorry. Right: check its fit and suitability.

Maintain your lorry and use its equipment without risking safety or the load.
Exam trap: Wrong: use petrol-engine spark-plug advice for your diesel lorry. Right: check the equipment it actually has.

Compare fuel use in similar conditions and keep emissions within the limits.
| Reading | What it tells you |
|---|---|
| Instantaneous consumption | Fuel use at that moment |
| Average consumption | Fuel use over a period |
Exam trap: Wrong: infer every exhaust emission from fuel use alone. Right: distinguish each type of emission.

Recognise your lorry’s environmental classification and its specific requirements.
| Classification | N2/N3 lorry criteria |
|---|---|
| 0 emissions | Blue; battery electric, extended-range electric, hydrogen, fuel cell, or plug-in hybrid with at least 40 km electric range on NEDC |
| ECO | Blue and green; gas vehicles, non-plug-in hybrids and plug-in hybrids below 40 km electric range; must meet C criteria |
| C | Green; petrol or diesel, Euro VI/6 |
| B | Yellow; petrol or diesel, Euro IV/4 or V/5 |
| A | No badge |
Exam trap: Wrong: assign ECO to any gas-powered lorry. Right: also check the C requirements.

Check your registered classification and display the badge where it belongs.
Exam trap: Wrong: assign a badge from fuel or year alone. Right: check registered details.

Check each low-emission zone’s rules before entering with goods.
Exam trap: Wrong: assume a badge allows entry into every ZBE. Right: check local rules.

Reduce unnecessary noise and keep the exhaust in good condition.
Exam trap: Wrong: use the horn to hurry someone. Right: use it only for a permitted warning.
Check that the route and the lorry allow you to complete the service without improvising.
Match the power demand to the engine speed you have after changing gear.
Use observation and space to avoid late braking.
Decide whether your lorry is authorised before entering the restricted zone.
Mark it as read and you will see your progress on the theory list.