Correct answer
Allow gases produced inside to escape.
Allow gases that may be produced, particularly during charging, to escape, preventing accumulation and dangerous pressure build-up. They are not intended to expel excess electrolyte or increase battery voltage. This description concerns that battery design; other types use different venting systems or valves and must not be opened like a battery with service caps.
Practice more C1 licence questions
A self-check with exam-style questions on Safe loading. Free, no signup.
All options
Deliberately expel excess electrolyte to adjust the level.
Allow gases produced inside to escape.
Increase the electrical voltage delivered by the battery.
Editorial status: editorially approved. This status does not certify legal review. Report a correction
Share this question
Keep studying
Related questions
- Drivers of goods vehicles with a Maximum Authorised Mass (MAM) exceeding 3,500 kg must not drive with a blood alcohol level higher than...
- An adult driver with more than two years of licence experience drives a lorry with a MAM below 3,500 kg for ordinary goods transport, without dangerous goods or another reduced-limit case. What general maximum breath-alcohol concentration must not be exceeded?
- In a conventional charging system with a working warning lamp, the lamp illuminates at ignition-on and goes out after starting. What does it normally indicate if it stays off while driving?
- As a general rule, what is the maximum width, including the load, permitted for lorries to be driven on the road?
- Coolant is found entering the oil in a liquid-cooled engine. Which of these internal faults can allow that mixing?
- What maximum-mass range defines international category N2 for motor vehicles designed and constructed primarily to carry goods?