Correct answer
Be of the type and amperage specified for that circuit.
It must be of the type and amperage specified by the manufacturer for that circuit. A fuse interrupts current when its limit is exceeded; it does not regulate circuit voltage. Do not fit a higher-amperage fuse or replace it with wire to prevent it blowing, as this removes the intended protection. Follow the manual’s procedure and have the fault checked if the fuse blows again.
Practice more D licence questions
A self-check with exam-style questions on Passenger transport rules. Free, no signup.
All options
Have a higher amperage so that it does not blow easily.
Be of the type and amperage specified for that circuit.
Be replaced with wire that keeps the circuit permanently connected.
Editorial status: editorially approved. This status does not certify legal review. Report a correction
Keep studying
Related questions
- For a D1 or D licence to be issued, the driver must already have:
- Between sunset and sunrise, a bus no longer than 6 m and less than 2 m wide, equipped with parking lights parks on an inadequately lit through road within a built-up area (travesía). In which parking position may its position lights be replaced by parking lights?
- A bus wider than 2.10 m travels through a signed tunnel, even during daylight. Must its end-outline marker lights be switched on?
- May the bus you are driving have front fog lights?
- Taking into account the volume of a bus, when is the wind most dangerous?
- If you are driving a bus and a traffic officer is directing traffic, you must: