Correct answer
No, correct the load arrangement so it does not obscure the lights.
No. Article 14 requires loads and accessories not to obscure mandatory lighting or signals. Correct the arrangement before travelling. Marking the projection with V-20 and, where required, a red light does not itself permit obscuring vehicle lights. Panel number and placement depend on projection width under Article 15.
Practice more C1 licence questions
A self-check with exam-style questions on Traffic signs. Free, no signup.
All options
Yes, a V-20 panel permits obscuring mandatory lights.
Yes, adding any red light is sufficient to authorise it.
No, correct the load arrangement so it does not obscure the lights.
Editorial status: editorially approved. This status does not certify legal review. Report a correction
Share this question
Keep studying
Related questions
- What is the duration of a traffic-signal cycle?
- You drive an ordinary 11-metre lorry on a dual carriageway outside a built-up area with two lanes in each direction, outside a tunnel and without minimum-gap signs. If you do not intend to overtake, what gap must you keep from the vehicle ahead?
- At an unsigned narrowing, without officers, roadworks or a steep gradient, a rigid lorry without a trailer and a bus entered together and one must reverse. Which one?
- Without intending to overtake, what minimum separation from the vehicle ahead does this sign indicate?
- To overtake a vehicle that is signalling with its indicator that it is about to change direction to the left, how will you carry out the manoeuvre?
- If we arrive in our lorry at a narrow section that does not allow two vehicles to pass simultaneously, and at the same time, but travelling in the opposite direction, a rider of a motorcycle without a sidecar arrives, which vehicle must pass first if there is no sign regulating passage?