DGT C licence questions: Mechanics and maintenance
Page 2 of 2 · Questions 101 to 156 of 156
- An articulated vehicle is defined as…
- What does the pressure gauge in the lubrication system indicate?
- An insulated vehicle has a mechanical-compression or absorption refrigeration unit that lowers and maintains its body temperature. Which…
- What does the word 'tubeless' mean on a tyre?
- When the windscreen washer reservoir is low, how should you replenish it?
- For efficient driving of a vehicle with a working synchromesh manual gearbox whose manufacturer does not require double-clutching, how…
- When driving a vehicle with a manual gearbox and clutch pedal, what helps avoid unnecessary transmission wear?
- When you turn on the ignition, the oil warning light comes on, and it goes off once the engine starts. What is this due to?
- At the same engine speed with no other changes, if oil becomes hotter and its viscosity decreases, how can this affect lubrication pressure?
- If your vehicle is fitted with a petrol engine and has a catalytic converter in the exhaust, what fuel should you use?
- Stopping distance is divided into...
- What does the aiming (adjustment) of a lorry's headlights consist of?
- When leaving the driving position after parking a 6,000 kg MAM lorry with a manual gearbox on a noticeable 8% slope, besides stopping the…
- In a truck, preventive maintenance of the braking system is important because:
- When driving on a stretch of road that is flooded with water, what consequences can a shock absorber in poor condition have?
- A driver without specialist training should leave replacement of certain lamps to a workshop because of high-voltage risk. Which lamps does…
- In a serviceable flooded lead-acid battery, the level has fallen through normal water loss during use. Following manufacturer instructions,…
- The engine oil dipstick is used to check...
- What is the part of the tyre that rests on the ground called?
- On a lorry with hydraulic power steering and a reservoir marked MIN and MAX, should you check its fluid level?
- In a hydraulic braking system, the pedal feels spongy and temporarily improves after repeated applications. Which of these may be a cause…
- When parking a vehicle with a trailer on a noticeable uphill gradient and leaving the driving position, a suitable kerb is available but no…
- In an engine, besides lubricating the moving parts and the cylinder walls, what other purpose does the oil serve?
- In a liquid-cooled engine whose coolant pump is belt-driven, which fault may reduce coolant circulation and cause overheating?
- A heavy lorry has a working electric retarder. On a steep descent with adequate grip and use permitted by the manufacturer, how should it…
- In a vehicle with a manual gearbox and a working conventional pedal clutch, when is the clutch engaged, coupling the engine to the gearbox…
- Before driving a lorry through very cold areas, what should you check about its coolant?
- A lorry has a body with insulated walls, doors, floor and roof to limit heat transfer, without a cold source or refrigeration equipment.…
- Should I regularly check the windscreen washer fluid level?
- Which gas is produced by complete combustion of the carbon in petrol or diesel fuel?
- Under the conventional arrangement described in the DGT mechanics manual, where is the engine cooling-system thermostat generally located?
- What main function do road-tyre tread grooves serve on a wet road?
- A lorry circuit requires nominal 24 V and has two compatible 12 V batteries. Which connection adds their voltages?
- An electrical accessory does not work while the others operate normally. The manual says to check its overcurrent protection first. Which…
- In a diesel engine with a conventional mechanical injection pump and rack-controlled fuel delivery, which assembly includes the governor…
- In a conventional four-cylinder, four-stroke engine, how far does the crankshaft rotate during one complete piston stroke from one dead…
- If, due to traffic conditions, a lorry with an MAM (maximum authorised mass) of more than 3,500 kg becomes stationary inside an underpass,…
- For an N2 or N3 lorry subject to Royal Decree 1417/2005, what speed must its compulsory limiter prevent it from exceeding?
- Is an articulated vehicle a vehicle combination?
- An insulated lorry uses a cold source other than mechanical compression or absorption equipment to lower and maintain its internal…
- A lorry is driven at night, with good visibility and no conditions permitting fog-light use. May it travel with position lights alone?
- In a lorry with a liquid-cooled combustion engine, the engine takes abnormally long to reach operating temperature. Which component…
- What risk does brake overheating from excessive use, for example on a long descent, create?
- When checking engine oil level with a dipstick, what conditions should you follow?
- In a conventional liquid-cooling circuit with a thermostat and internal bypass, how does the thermostat help a cold engine warm up?
- What does the word TUBELESS printed on the side of the tyre mean?
- During normal driving while maintaining steering control, the vehicle persistently pulls to one side without an apparent road or wind…
- By day, a lorry without front fog lamps and with no main beam in use travels on an interurban road in light snowfall that significantly…
- Between sunset and sunrise, a lorry travels on a sufficiently lit through-road in a built-up area with no adverse weather. In addition to…
- When leaving the driving position after parking a 6,000 kg MAM lorry with a manual gearbox on a noticeable 8% slope, besides stopping the…
- What general term covers changes such as joining traffic, moving into another lane or turning, which alter the vehicle’s normal progress?
- Before starting the day with a truck it is advisable to carry out:
- If my lorry's steering is hydraulically assisted, should I check the steering fluid level?
- What benefit is supported by keeping lorry tyres at the recommended cold pressure for their load?
- If your lorry’s engine takes too long to reach normal operating temperature, which component should be checked?
- Your lorry has a coolant expansion tank marked MIN and MAX. Under the manufacturer’s specified checking conditions, how should you check…